I started working on some furniture for the scale garage. First on the list was the desk and chair. Once I figured out the size (measured the one I use and divided it all by 10) 

That took me all of about 30 minutes to do. Was pretty simple and straight forward. A lick of paint and presto, done

Then came the chair. Where does one start? So I sat Ruff's ass on some styrene and, using a pencil, marked around him and left some extra room.  This gave me the seating area of the chair. Then cut the backrest and continued from there.

Glued the backrest on

Glued some legs (had to do them twice as one was too short.

Sat Ruff on the chair to try it out and I personally think it turned out just fine.

Here is what it looks like from the seating position

and here is what it will look like to the clients who will be invited to the garage office  

This is my first attempt at doing this, I think it went well, not perfect but good enough. Looking forward to the rest of the furniture